EP911 on SS2000SM
Posted: Mon May 18, 2009 11:51 am
I am new to installing SS2000sm...
I have the unit installed, sirens work no problems, control head lights up, but not sure how to install the EP911TD/WL24. I am installing the EP911, hideaway strobes in all the front and rear vehicle lights, and a small LED dash light in the front. On the SS2000sm I have the main LARGE power cable hooked up through a circuit breaker from the vehicle battery to the SS2000sm unit, and the second power supply wire to a key controlled connection. On the signal master I have that hooked up to power and grounded, but there is no wiring diagram for installing the EP911. On the back on the SS2000sm there are 11 pins for the signal master, how would I hookup the EP911, it only has 5 or 6 wires. I have tested the relay 1,2,3 and they all have continuous power if the SS2000sm unit is on, so when I turn the vehicle on the EP911 comes on without any buttons being activated on the control head... Please help.
Thanks
I have the unit installed, sirens work no problems, control head lights up, but not sure how to install the EP911TD/WL24. I am installing the EP911, hideaway strobes in all the front and rear vehicle lights, and a small LED dash light in the front. On the SS2000sm I have the main LARGE power cable hooked up through a circuit breaker from the vehicle battery to the SS2000sm unit, and the second power supply wire to a key controlled connection. On the signal master I have that hooked up to power and grounded, but there is no wiring diagram for installing the EP911. On the back on the SS2000sm there are 11 pins for the signal master, how would I hookup the EP911, it only has 5 or 6 wires. I have tested the relay 1,2,3 and they all have continuous power if the SS2000sm unit is on, so when I turn the vehicle on the EP911 comes on without any buttons being activated on the control head... Please help.
Thanks