Page 1 of 1
Posted: Tue Jan 08, 2002 9:34 pm
by Burner
Not up on programming Trunking radios, I looked at this radio on RSS but no place to enter freq's?? How does this work
Posted: Thu Jan 17, 2002 5:51 am
by RESCUE161
I'm having the same problem???
did you figure it out?
Posted: Thu Jan 17, 2002 12:09 pm
by eacradio
Maxtrac 820 is a trunking radio; the only freqs you enter are the control channels that are entered in the system info screen. You also need a system key to do this.
Posted: Thu Jan 17, 2002 2:17 pm
by wavetar
If all you see after reading the radio is the "F2 - Radio Wide Configuration: Time Out Timer" under the "Change/Create/View" menu, then you are both trying to read a Trunking Maxtrac with Conventional Maxtrac RSS (RVN-4019). You need to use the separate Trunking Maxtrac RSS, part# RVN-4043.
Todd
Posted: Fri Jan 18, 2002 6:23 am
by RESCUE161
Well, that leaves me out, I only have Maxtrac Lab RSS...
oh well...
Posted: Fri Jan 18, 2002 3:24 pm
by wavetar
You are correct, there are separate LAB RSS for the trunked & conventional Maxtracs as well.
Posted: Fri Jan 18, 2002 8:40 pm
by Burner
Same with me all I have is Lab RSS, poop